Setting up a hookah can be a fun and enjoyable experience. Discover tips and tricks for proper assembly and enjoy a relaxing session with our easy-to-follow instructions. Enjoy it responsibly and buy hookah from HookahMarket by following any local regulations regarding its use. Here’s a step-by-step guide to help you set up your hookah properly:

Base Preparation

Make sure the water level in the base is between one and two inches above the stem before beginning to fill it. In addition to creating a smooth smoking experience, this is done to ensure proper filtration. It is imperative to avoid overfilling the base because doing so could lower the smoke’s quality.

Connect The Stem

– Ensure a tight fit as you insert the hookah stem into the base.

– Put the rubber grommet, if your hookah has one, on the stem’s bottom to make an airtight seal with the base.

Attach The Tray

– Slide the hookah tray onto the top of the hookah stem.

– Ensure it sits securely and level on the stem to catch any falling ash or debris.

Prepare The Bowl

– Choose a hookah bowl that suits your preferences and pack it with hookah tobacco. Fluff the tobacco slightly and avoid overpacking or pressing it too tightly to allow for proper airflow.

– Place a piece of hookah foil over the bowl or use a heat management device such as a Kaloud Lotus.

– If using foil, ensure it is tightly stretched over the bowl, leaving a small gap between the tobacco and the foil for heat circulation. Secure the foil by pressing it firmly around the edges of the bowl.

Add Charcoal

– Ignite charcoal using a lighter or a charcoal burner until it turns red-hot and is covered with a layer of white ash.

– Place the charcoal on the hookah foil or heat management device.

– Start with one or two charcoal pieces and add more if needed to maintain consistent heat throughout the session.

Connect The Hose

– Attach the hose to the hookah stem’s hose port.

– If the hose doesn’t fit directly, use adapters to ensure a secure connection.

Check For Leaks

– Ensure all connections are tight and there are no air leaks.

– Test the hookah by gently pulling through the hose to see any leaks. If you notice air escaping from any joints, reassemble and tighten them.

Let It Heat Up

– Allow the hookah to heat up for a few minutes to ensure the tobacco gets adequately heated.

– During this time, you can take a few gentle draws to help the heat distribute evenly.

Enjoy Your Hookah

– Once the hookah is adequately heated, take a slow, steady draw through the hose.

– Relax, savor the flavors, and enjoy your hookah session. Choose the best hookah and shisha heads from our collection.